Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Not enough DSP resources available to configure pri-group on controller E1 0/0/0

Hi All,

i m getting below error can any one know the solution.

Please help.

dldsipgw(config-controller)#pri-group timeslots 1-16
% Not enough DSP resources available to configure pri-group on controller E1 0/0/0
% The remaining dsp resources are enough for 0 time slots.
% For current codec complexity, 1 extra 16 channel dsp(s) are required to create this voice port.
dldsipgw(config-controller)#

2 REPLIES
VIP Purple

Buy more DSP resource.

Buy more DSP resource.

New Member

Hi raffi

Hi raffi

Do you have PVDM on your gateway, if yes then this mean the capacity is low and shall be increased to accommodate the PRI you are trying to configure.

check sh inventory and check for the PVDM you have and accordingly you can get the new one.

Regards

58
Views
0
Helpful
2
Replies