Do you have HTTP proxy enabled or are you using WSP (WinSock Proxy) only?
With HTTP proxy, this feature will be supported with the firmware loads that will come with CallManager 3.1. I am not positive at this time if the scripting options to enable this will be bundled with the CallManager. I think more likely it will be part of an SDK for IP Phone Services, similar to the one currently available at:
If you mean you want to have the IP phones on one side of the NAT router and the CallManager on the other, so you would need to translate the Skinny signaling, then yes, you can do this on an IOS router using 12.1(5)T or later. See this URL:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...