Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

ntp question

HI

Based on this link

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_implementation_design_guide_chapter09186a0080447513.html#wp1043704

I have 2 questions:

1. Do I configure ntp.conf ONLY on the Pub and not the Sub as I heard that the sub automatically picks up time on the Pub so I do not have to modify the ntp.conf on the sub.

2. Anyone play around with the "tinker panic" command? If so, what is the recommend seconds you use?

Thanks

2 REPLIES

Re: ntp question

You will need to configure ntp.conf on each server in the cluster or disable NTP and use an alternative method to synchronize the time as described in the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008009470f.shtml

I leave the tinker panic at the default as you normally will not see an offset greater than 1000 seconds.

Hope this helps. If so, please rate the post.

Brandon

Re: ntp question

1/ correct, you only need to configure ntp.conf on the Publisher, if you install a Subscriber it will have the ntp.conf configured to sync on the Publisher......

just open the file to check!

c:\winnt\system32\drivers\etc\ntp.conf

119
Views
0
Helpful
2
Replies
CreatePlease to create content