Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Number of Conference participants

Everything I have read regarding the 6608 or the VG200 states that only 6 participants are supported on a conference bridge. I have a need to have at least 10 people in a conference. Am I missing something here, or do I need to purchase a third party conference bridge that can handle more than 6 participants?

2 REPLIES
Cisco Employee

Re: Number of Conference participants

6 is the default as configured in the Service Parameters. With the 6608, unofficially you should be able to get 16 without a problem, or more depending on which versions of software are being used. This is not supported as I said but I don't know of any problems relating to this. Also not sure if the VG200 has the same numbers or not.

If you want to look at another system you can use Cisco Conference Connection which is housed on another server and will allow you to schedule conferences, etc.

New Member

Re: Number of Conference participants

I am using CCM 3.1, where are the service parameters you speak of? I have found CFB: Call Count which is set to 48, and also MaxAdHocConference and MaxMeetMeConferenceUnicast are both set to 10. I am using a VG200 right now and if I try to conference in more than 6, the IP phone just hangs up. Do I have the correct service parameters?

207
Views
0
Helpful
2
Replies
CreatePlease to create content