Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

occasional no ring-back on E1 in Germany

I have a 1751 router with a VWIC multi-flex trunk card and a E1 circuit connect to Deutsche telecom. The user ocassionally hears no ring-back tone when placing outbound calls on the PRI. Here is the config for the 9T dial-peer outbound.

!

dial-peer voice 900 pots

destination-pattern 9T

progress_ind setup enable 3

progress_ind progress enable 8

progress_ind connect enable 8

port 0/0:15

!

Does anyone have any other suggestions?

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: occasional no ring-back on E1 in Germany

Try adding the following command under the pots dial-peer. It might help.

progress_ind alert enable 8

New Member

Re: occasional no ring-back on E1 in Germany

I have the same in the netherlands.

Some PSTN devices are unable to generate ringback tone.

configure the "tone ringback alert-no-pi" on the pots dialpeer to fix this.

120
Views
0
Helpful
2
Replies
This widget could not be displayed.