Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Old overhead paging system

Hello Netpro,

I have a client that wants to reuse his old overhead paging system. It's basically an amp with an RCA plug as input. How would I go about connecting it to their new IP Telephony setup? I was reading the cisco doc about using E&M interfaces, but I'm not sure how to interconnect the E&M interface to that RCA.

1 REPLY
Hall of Fame Super Red

Re: Old overhead paging system

Hi Pablo,

You can use the Part below with an FXS port and it has an RCA connector output for connection to the Amp. This TAM-B is required in 99% of the cases I have seen.

Something like this;

http://www.camelectronics.com/botateacmo.html

Hope this helps!

Rob

162
Views
0
Helpful
1
Replies
CreatePlease to create content