I am missing something basic I am sure, I have read through the white papers and the Unity install guides. but I cannot get Message waiting to work across the cluster. Unity takes messages fine it just will not turn on a light.
The only thing I am getting out of those White Papers and Guides are that there needs to be a dedicated MWI Port for each cluster. So I have done that, but now what? My cisco-TSP points to one of the clusters but how do I get that port that I dedicated to lighting the lights on my other cluster, start light lights? I have set up a voice mail pilot and message waiting extensions on the remote cluster.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.