I'm using cisco3825 as a voice gateway with concerto dialer software for outbound dialing for a call center.Agents are facing voice problems :like they can hear the customer but customer can't hear them.But it's not for all the agents at a time.
I tried out and found some logic.Dsp resources which are using g711ulaw tx is 0, so voice no transmit.However no issue with g729r8 codecs
Attaching my voice cofig and output.
Is there any way only g729 codec use no g711 ???I'v tried several options but still not found any solution.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.