Trying to setup OPX line from residence to remote office where there is a 3845 voice gateway. This is a remote site since CCM is in another state. Not sure if a FXS port needs to be setup or how to setup with carrier to complete the point to point. CCM 4.1.3
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.