outbound caller id - PRI - CCM3.3.3 - H323 gateway
I getting closer on this PRI but it's not quite there yet. I can't get outbound caller id to work. The ISDN switch type is primary-ni. Variance in NI2. I have the gateway configured as H323. Outbound calls work but the caller ID data is not sent.
Re: outbound caller id - PRI - CCM3.3.3 - H323 gateway
I tried to change the caller ID to 10 digits and now I don't see the calling party number in the debug. I changed the Caller ID DN from a format of 12345XX to 206XXXXXXX. When I change it to 20612345XX it works. I have two different blocks of DID numbers so I need the first (206XXXXXXX) to work.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...