Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Outbound Dial Peer

Can anyone pls help me, about inbound dial peer? My setup is I have a 7200 VXR connected to a 5ess switch via a T1 connection. The the 7200 VXR acts as a gateway and gatekeeper, and i also setup a ATA-186 on the other network for me to make a inbound and ountbound calls. Using the ATA-186 i can make a call outbound by pulling a second dial tone via the 5ess without a problem.. my problem is when i make a inbound call from the pstn then the 5ess forwards the digits to my gatekeeper. i get a dial tone instead of a ring from ATA.

Hope anyone can help me with these dial-peering..

thank you very much

  • Other Collaboration Voice and Video Subjects
1 REPLY
Silver

Re: Outbound Dial Peer

Can't confirm without seeing the configs, but you probably need 'direct-inward-dial' on the first POTS dial peer that references the voice ports the calls are coming in on. This configures the router to accept the DNIS and then make a match on other dial peers (single stage dialing)

88
Views
0
Helpful
1
Replies
This widget could not be displayed.