Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Outgoing calls at ATA 186

Hi,

I have a problem with ATA 186 (Version v2.15) in H.323 Mode. The ATA is configured as H.323 Client at CallManger Version 3.2(2c). Incoming calls at the ATA work properly, but outgoing calls don't. I can hear the dial tone at the analog phone, but dialing doesn't take effekt.

Thanks,

Hannes

4 REPLIES
Bronze

Re: Outgoing calls at ATA 186

Dial tone is locally generated from the ATA, so it would generate that pretty much regardless of the situation. First step is to check the CallingSearchSpace associated with the ATA. Can you not dial outside or inside, or can you dial inside phones?

Rick

New Member

Re: Outgoing calls at ATA 186

Thanks for your help.

I don't use CallingSearchSpace. I have a very small network (5 phones) for testing CallManager funktions. I am able to call the analog phone from another, the speech connection also work properly, but it's not possible to place calls at the analog phone.

New Member

Re: Outgoing calls at ATA 186

Try to punch the pound key after dialing out phone numbers.

New Member

Re: Outgoing calls at ATA 186

Hannes,

I think the problem is your Codec Settings, it should match the settings of your callmanager to your LBR Codec, AudioMode, TXcodec and RXcodec. Try these config it Might Help.

LBR Codec = 3

AudioMode = 0x00000002

RxCodec = 2

TxCodec = 2

Goodluck

114
Views
0
Helpful
4
Replies