Is this call from an ip phone with callmanager or cme ? with callmanager, you need to set ext. ph number mask on the phone and then set the route patterns to send the mask (either at route pattern level or at route list level).
With CME, you will need to use dial plan patterns or translation profiles.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.