11-08-2006 11:08 AM - edited 03-13-2019 03:42 PM
I just upgraded my C2650XM to IOS 12.4(9)T1 because I had instability problems with the old 12.4(4)XC2, the router had to be manualy rebooted from time to time.
This seems to be solved in the new IOS, however now I'm not able to make outgoing calls on the VIC-2BRI-S/T-TE. Why?
I didn't change the config after upgrading and incoming calls still work fine.
Here is the config, I hope something is wrong so I don't have to downgrade back to 12.4(4)XC2.
!
voice translation-rule 2
rule 1 /^/ /0/
!
voice translation-profile ADD-INCOMING-ZERO
translate calling 2
!
voice-port 1/0/0
translation-profile incoming ADD-INCOMING-ZERO
compand-type a-law
cptone DK
!
interface BRI1/0
no ip address
no logging event link-status
isdn switch-type basic-net3
isdn tei-negotiation first-call
isdn tei-negotiation preserve
isdn incoming-voice voice
!
dial-peer voice 2 pots
preference 2
destination-pattern 0T
incoming called-number XXXXXX.. <---removed
direct-inward-dial
port 1/0/0
Debug isdn q931 shows what I would expect, however the Layer 1 Status of the ISDN doesn't change from DEACTIVATED to ACTIVATED as I would have expected, I think this is something to do with why dialpeer.
If anyone could help me out, I'll really apriciate it. And if you need more info, please write.
11-08-2006 11:23 AM
When BRI L1 status is normally deactivated, you need
no dial-peer outbound status-check pots
in global config.
11-08-2006 01:32 PM
Well at least now the Layer 1 status is ACTIVE, thanks.
However I'm still not able to make outgoing calls.
I think I need to go back to the unstable software :-(
11-08-2006 03:04 PM
Check output of debug isdn q931 and show dialplan number perhaps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide