Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Outside line without prefix CME

Hi

I am configuring a demo system on a 2811 router with bri interface. I would like to avoid prefix for an outside line. The local phones are numbered 201 to 236.

Right now the dial-peer conf is

dial-peer voice 1 pots

destination-pattern [2-9].......

incoming called number xxxxxx

direct-inward-dial

port 0/0/0

This works ok. I gets and recieves calls, as log as i dont try to call numbers starting with 201 to 236.

Is there any way to tell the router that it should consider calls to numbers longer than 3 digits to be to the outside world ?

/Per

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Outside line without prefix CME

Dear Per

What you need to do is to create two new dial peers with the following destination patterns pointing at the same voice port

destination-pattern 2[0-2]..T

destination-pattern 23[0-6].T

note the T which provides the timeout.

This may make internal calls from analog phones to have long post dial delay, as you are now having to wait for the 4th digit. You can minimise this by the command on the voice port for analogue phones.

timeouts interdigit

3 REPLIES
New Member

Re: Outside line without prefix CME

Dear Per

What you need to do is to create two new dial peers with the following destination patterns pointing at the same voice port

destination-pattern 2[0-2]..T

destination-pattern 23[0-6].T

note the T which provides the timeout.

This may make internal calls from analog phones to have long post dial delay, as you are now having to wait for the 4th digit. You can minimise this by the command on the voice port for analogue phones.

timeouts interdigit

New Member

Re: Outside line without prefix CME

Thanks :-)

I get the idea !

/Per

New Member

Re: Outside line without prefix CME

But not the function :-(

No mattter what i do, as soon as 202 is dialed, i get a local phone.

debug voip dialpeer shows Partial Matches (1) as soon as the first digit is processed.

Why dosent it consider the other dial-peers stating with 2 ?

Is is totaly imposible to get this to funktion ?

/Per

171
Views
0
Helpful
3
Replies
CreatePlease to create content