I installed unity (VM) 4.0(2) on MCS7835 with exchange 2000. One CallManager 3.3(3) on another MCS7835. VG200 as an H323 voice gateway.
I tried to use the option of message notification function for coming new messages for a subscriber. So I configured on the Message notification under subscriber with an outside phone(PSTN).
I tested that if a new message coming, unity will dial the configured outside phone, but when I accept the call from the Unity,and entered Subscriber ID, entered password, then the Call was disconnected. So I have no way to retrive the message if the call was from unity notification.
If the configured phone no. is an IP Phone, it is okay. I can retrive the message from the notification.
So I am thinking is there any issue on the vocie gateway for this?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.