Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Paging with Valcom 2924A

Hello,

I have an FXO port configured with MGCP (VIC2-2FXO) that I am attempting to use for paging to a Valcom 2924A amplifier.

When I attempt to send a call to the port, the call appears to connect, but the user is immediately disconnected.

Has anyone had experience configuring a simliar paging scenario? I've configured with several Bogen devices, but this one is not working like I expect.

Thanks much!

1 REPLY
Bronze

Re: Paging with Valcom 2924A

The paging system provide very high pitch tone and FXO port doesn't recognize it. Sometime asking the telco to changing the impedence impedence and reduce the tone can help . Usually, this kind of paging system works with E&M ports.

Changing the card to a FXS card can help you . try out if you have not done . you can also refer link below

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008015094e.shtml

332
Views
0
Helpful
1
Replies