Not sure if this is the right place for Linksys VOIP hardware - though Cisco moved everything onto their site...
I have a PAP2T that seems to have trouble letting some analog devices dial out. Specifically, I tried it with a credit-card machine, and it seemed like the PAP2T would never go off-hook so it could dial. I saw no SIP traffic for any dialing. However, I immediately plugged the same FXS port into a fax machine, and that fax machine was able to dial out fine.
Re: PAP2T - some devices cannot go off-hook to dial
Before you set up port forwarding on your router, change two of the Phone Adapter's settings using its Interactive Voice Response Menu. First, disable its DHCP feature, then assign a static IP address to the Phone Adapter.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...