Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Partial PRI

I am attempting to configure a PRI with 14B + 1D channel using MGCP. Is there any difference between configuring a full PRI?

Thanks

1 REPLY
Hall of Fame Super Silver

Re: Partial PRI

Partial PRI is not supported with MGCP, you need to use H.323.

There is an unsupported way of using MGCP by putting individual B channels out of service on CCM. Follow this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=IP%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddaa267/0#selected_message

HTH, please rate all posts!

Chris

199
Views
0
Helpful
1
Replies