I am having a tuff time configuring CCM partitions. In order to make this implematation worth while I need to have this operate.
When I have my Gateway, RG, RL, and pattern setup with a partition on the DN or the pattern the phones dial out and in. As soon as I put the partition dropdown in for the DN and the partition, it all goes south!
No in or out. What gives? Using this CCM to do a small Voip service provision and need to really drill down on the access of the DN's and devices.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.