You need one of the following 3 bundle part numbers:
Each comes with:
- NM-HDV card (high-density voice network module)
- 1- or 2-port VWIC-MFT card (T1 or E1)
- PVDM-12 DSP modules
Assuming you are in North America and using a T1 interface on the Nortel PBX, you would use the NM-HDV-1T1-24 if you wanted only a single PRI connection, and plan to run a medium-complexity codec such as G.711 or G.729a
If you needed only one port and plan to run the calls at a high complexity codec such as G.723.1 then you may purchase the NM-HDV-1T1-24E.
If you need 2 ports and plan to run medium complexity codecs then you may purchase the NM-HDV-2T1-48.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...