I have a FR network with a 2500 on the hq and 1600's on 3 remote sites all running basic IP images.
We are going to put some IP pabxs on all of the sites directly connected to the ethernet and I would like to know about sample configs/info on QoS to implement on the Ciscos to pass the Voice traffic from these pabxs over the FR network.
Some questions to be clarified would be: Can we and shall we configure separate PVCs for data and voice (on the same interfaces), shall we make provision for any queuing techniques, is the basic IP image enough to do this or do we need other type of images ??
Make sure that you have the appropriate code levels. Your best bet is to make sure you have something in the 12.2 arena. As far as your particular models, I am not sure if they support the QOS functions you will need, but I would seriously consider upgrading those routers to either a 1720 and a 2600 or just get 2 Cisco 2600. 1600's are quite old and you run into the likelyhood of overrunning the processor. Once you get everything sorted out email me at firstname.lastname@example.org and I can provide you with some more detailed configurations.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...