Hi Everybody, i have an situation with Cisco Desktop Supervisor, I installed sucessfully the Cisco Desktop Agent and could logon with the supervisor user that i previously created, but, when i try to logon to the Cisco Desktop Supervisor with the supervisor user it send a message that says Invalid Password or Not Valid Password (i cannot remember the right sentence, but means the same).
I checked that the user is a supervisor at the Cisco Administrator Desktop and the User Mantenance on the CRA Administrator.
What could be causing the problem? If somebody have a clue from where to start ill apreciate it.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.