Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

PBX integration with IP network for trunk carrier

Dear All,

I need to connect Legacy PBX present at different locations through IP network.

What Device will require for call setup management in the IP network for call managing and call handling for the call generated from one phone connected to one PBX destinated to phone connected to other PBX.

With Regards

Anand

2 REPLIES

Re: PBX integration with IP network for trunk carrier

That will all depend on what your Legacy PBX is. Ca you give the make and model info? Off the top of my head you will need either an FXS or an FXO card and possible a router/gateway as well but we need more information to give you a definite answer.

Hope this helps.

Please remember to rate all replies

New Member

Re: PBX integration with IP network for trunk carrier

Dear Sir,

Thanks for the reply. The PBX is Nortel make.

Is only voice supported router with FXS interface is sufficient to do so or call manager or any other third device will required.

Kindly revert me back

With Regards

Anand

109
Views
0
Helpful
2
Replies
CreatePlease to create content