Hello,<br>Assuming the integration of Unity 2.46 with a Nortel or Lucent PBX, I think the following is required. Can you verify and elaborate on these requirements?<br><br>-20 Port Solution - Lucent or Nortel: Is this the licensing?<br>-Dialogic D120 12 port board: Is this a PCI board?<br>-H.100 8 port drop: What is the function of H.100 port drop?<br>-PBX Link: Is this the RS232, Calista, or T1?<br><br>Thanks for your time!<br><br><br>
The 20 port solution is the number of ports unlocked on the key with this configuration. The Dialogic D120 12 port board is PCI. For 20 ports you would need two of them linked with a CT connector cable. The 8 port drop is your CT connector cable for linking multiple dialogic PCI boards. PBX Link -- this is the Calista device which has both a digital station port for your Lucent/Nortel line, and an RS-232 serial connector for passing SMDI info to Unity.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...