I am installing Unity 3.1x on a ICS7750 after Exchange is installed I am getting errors in the Event Viewer listed below. I searched CCO, here, and MS Support and cannot find details, any ideas???? I have installed once with this error, rebuilt the server followed the instructions completely and still received this error?<br><br><br>EVENT: <br>Source: Perflib<br>Event ID: 1008<br>Type: Error<br>Description: The Open Procedure for service "ISAPISearch" in DLL "C:\<computername>\System32\query.dll" failed. Performance data for this service will not be available. Status code returned is data DWORD 0.<br><br><br>
How to stop Performance Monitor Errors in the Event Log
Without going into a huge discussion of the inner workings or limitations of Performance Monitor, this is actually expected. The errors are created when a windows components loads improperly or has erroneous information in the registry in its hook to Performance Monitor.
The errors can be quelled by either removing the Open value from HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\:\Performance (your service may vary)
by changing the more global setting ExtCounterTestLevel down to something like 3 in the registry. (see Q226494, it also has a good explanation of the errors.)
If setting the test level for the performance counters still produces errors, setting the EventLogLevel registry value to 0 will stop all errors from being reported. This is not entirely recommended, but setting it to 1 or higher should reduce the amount of errors in most cases.
Anyhow, for more information, i will refer your attention to the following Microsoft Knowledge Base articles:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...