Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Phone Is Ringing, But Calls Are Not Being Completed

We have a private branch exchange (PBX) connected to an AS5300 universal access server that initiates a call to a PBX connected to a Cisco 3640. The phone rings, but there is only a brief squeal and then nothing. The calls coming from the other way are fine. The following is the path the call takes:

<p>

pbx-5300-7200-FR-3640-pbx

<p>Why are my calls not being completed?

1 REPLY
Anonymous
N/A

Re: Phone Is Ringing, But Calls Are Not Being Completed

If the phone rings then I would suppose signalling

is fine hence ip routing is enabled on

both originating and terminating gateways.

However if no proper QOS is enabled for voice within

your network , then its quite possible that the voice call will

fail as its not at all tolerant to end-to-end delay greater than 150ms.

1. Check you round trip delay for a ping packet

2.do a few "sh call active voice" command and compare the transmit and receive

rtp streams to see if you're sending voice pakets

and receiving.

3. check you QOS config

97
Views
0
Helpful
1
Replies
CreatePlease login to create content