Hello,
I currently have a Cisco 3825 with IOS 12.4(1)b thus implementing CME 3.3.
Running the 'show ephone phone-loads' I've detected the following regarding my 7940-7960 IP Phones:
hostname#sh ephone phone-load
DeviceName CurrentPhoneload PreviousPhoneload LastReset
=====================================================================
SEP00138054D471 3.1(MF.G2) 3.1(MF.G2) Initialized
SEP00141C316531 3.1(MF.G2) CM-closed-TCP
SEP000DBDFDA81B 5.0(6.0) CM-closed-TCP
SEP00138054D494 3.1(MF.G2) CM-closed-TCP
SEP00141CA54173 3.1(MF.G2) CM-closed-TCP
SEP00138054E5D5 3.1(MF.G2) 3.1(MF.G2) Reset-Reset
SEP0013C3BAA859 3.1(MF.G2) CM-closed-TCP
SEP0013C44A7DD2 3.1(MF.G2) CM-closed-TCP
SEP0013C3BAA8DA 3.1(MF.G2) 3.1(MF.G2) CM-closed-TCP
SEP00141C8DDB23 3.1(MF.G2) 3.1(MF.G2) Initialized
SEP00141C6A016E 3.1(MF.G2) CM-closed-TCP
SEP00138054D495 3.1(MF.G2) CM-closed-TCP
SEP00138054D472 3.1(MF.G2) CM-closed-TCP
SEP0013806C2A08 3.1(MF.G2) 3.1(MF.G2) Reset-Reset
I've also seen that the phone loads for this CME version are not the most correct:
I have P00305000600.sbn instead of P00307020200.sbn.
And this is what leads to my question.
Beeing the MF the factory defaults, can I go directly to P00307020200? Or do I have to take additional intermediate steps?
Best Regards,
Pedro