Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Phone Loads problem in CME 3.3

Hello,

I currently have a Cisco 3825 with IOS 12.4(1)b thus implementing CME 3.3.

Running the 'show ephone phone-loads' I've detected the following regarding my 7940-7960 IP Phones:

hostname#sh ephone phone-load

DeviceName CurrentPhoneload PreviousPhoneload LastReset

=====================================================================

SEP00138054D471 3.1(MF.G2) 3.1(MF.G2) Initialized

SEP00141C316531 3.1(MF.G2) CM-closed-TCP

SEP000DBDFDA81B 5.0(6.0) CM-closed-TCP

SEP00138054D494 3.1(MF.G2) CM-closed-TCP

SEP00141CA54173 3.1(MF.G2) CM-closed-TCP

SEP00138054E5D5 3.1(MF.G2) 3.1(MF.G2) Reset-Reset

SEP0013C3BAA859 3.1(MF.G2) CM-closed-TCP

SEP0013C44A7DD2 3.1(MF.G2) CM-closed-TCP

SEP0013C3BAA8DA 3.1(MF.G2) 3.1(MF.G2) CM-closed-TCP

SEP00141C8DDB23 3.1(MF.G2) 3.1(MF.G2) Initialized

SEP00141C6A016E 3.1(MF.G2) CM-closed-TCP

SEP00138054D495 3.1(MF.G2) CM-closed-TCP

SEP00138054D472 3.1(MF.G2) CM-closed-TCP

SEP0013806C2A08 3.1(MF.G2) 3.1(MF.G2) Reset-Reset

I've also seen that the phone loads for this CME version are not the most correct:

I have P00305000600.sbn instead of P00307020200.sbn.

And this is what leads to my question.

Beeing the MF the factory defaults, can I go directly to P00307020200? Or do I have to take additional intermediate steps?

Best Regards,

Pedro

1 REPLY
New Member

Re: Phone Loads problem in CME 3.3

Should be fine fine to goto the new image.

Telephony-Service

create cnf files

just rememnber to add the TFTP-SERVER flash:imagename commands to the router...

158
Views
0
Helpful
1
Replies
CreatePlease to create content