I'm getting this on both fast dial service and address book. I get this message when I press the services button then try to search for an entry in the address book. This user does have a PIN and password assigned. I have also made sure the PIN was correct in the service.
The User ID and PIN should be set when you subscribe a phone to the service, not in the setup for the service itself. The parameters get setup when you configure the service, but the values for a particular user are entered at the time you subscribe to the service. The link in my previous post gives the exact parameters that need to be setup for the service and shows the process for entering the values specific to a user.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...