Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pilot Point Locking Up for Inbound Calls on CM 3.09

We have two 3.09 Call Managers deployed Using Pilot Points receiving an average of 100 calls per hour at some peak periods. Once in a while the Pilot point locks up, and the number will ring busy. Sometimes we can reset the telephony dispatcher in the control center and it frees up, but most of the time we have to reboot the server. Anyone else run into this??

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: Pilot Point Locking Up for Inbound Calls on CM 3.09

There are several known bugs in 3.09 (check the release notes on CCO). This may be one of them. I have my customers on 3.010 and they are not experiencing this problem.

New Member

Re: Pilot Point Locking Up for Inbound Calls on CM 3.09

I have a similar issue on 3.0(10) where we have to stop/start the TCD to workaround. I have a TAC case but no fix as yet

98
Views
0
Helpful
2
Replies