Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

plan type messages on 5350

hi,

I have a 5350 connected to PSTN via T1 PRI. when calls comes or send to PSTN i see a plan type message for every call. I have also configured 5300 in some other locations connected with E1 PRI with the same config but i dont get such messages on them. Messages are

*Mar 21 08:09:29: ISDN Se3/1:23: overriding plan/type for 0292211560, isdn/national to isdn/subscriber

*Mar 21 08:09:29: ISDN Se3/1:23: overriding plan/type for 0292211560, data/unknown to isdn/subscriber

*Mar 21 08:09:40: ISDN Se3/0:23: overriding plan/type for 0292311766, isdn/national to isdn/subscriber

*Mar 21 08:09:40: ISDN Se3/0:23: overriding plan/type for 0292311766, data/unknown to isdn/subscriber

*Mar 21 08:09:45: ISDN Se3/0:23: overriding plan/type for 3402, unknown/unknown to isdn/subscriber

*Mar 21 08:09:45: ISDN Se3/0:23: overriding plan/type for 0119910978, isdn/unknown to isdn/subscriber

*Mar 21 08:09:45: ISDN Se3/0:23: overriding plan/type for 3402, data/subscriber to isdn/subscriber

*Mar 21 08:09:45: ISDN Se3/0:23: overriding plan/type for 0119910978, isdn/unknown to isdn/subscriber

*Mar 21 08:10:06: ISDN Se3/0:23: overriding plan/type for 0292211560, isdn/national to isdn/subscriber

*Mar 21 08:10:06: ISDN Se3/0:23: overriding plan/type for 0292211560, data/unknown to isdn/subscriber

*Mar 21 08:10:07: ISDN Se3/0:23: overriding plan/type for 0292191221, isdn/national to isdn/subscriber

*Mar 21 08:10:07: ISDN Se3/0:23: overriding plan/type for 0292191221, data/unknown to isdn/subscriber

*Mar 21 08:10:47: ISDN Se3/0:23: overriding plan/type for 0292299560, isdn/national to isdn/subscriber

*Mar 21 08:10:47: ISDN Se3/0:23: overriding plan/type for 0292299560, data/unknown to isdn/subscriber

configuration for T1 are

interface Serial3/0:23

no ip address

no logging event link-status

isdn switch-type primary-dms100

isdn not-end-to-end 64

isdn incoming-voice modem 64

isdn map address .* plan isdn type subscriber

fair-queue 64 256 0

no cdp enable

!

interface Serial3/1:23

no ip address

no logging event link-status

isdn switch-type primary-dms100

isdn not-end-to-end 64

isdn incoming-voice modem 64

isdn map address .* plan isdn type subscriber

fair-queue 64 256 0

no cdp enable

Waiting for reply. Thanks

1 REPLY
Bronze

Re: plan type messages on 5350

Probably you should enable debug isdn q931 to get a better picture with the issue. I guess this is only warning to some minor issue which can be ignored if you do not have problems with the call placement.

147
Views
0
Helpful
1
Replies
CreatePlease to create content