Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Plar on fxs port

We have CM/VG248 with fxs port, I am trying to configure opx off FXS port.

Any suggestions?

4 REPLIES
New Member

Re: Plar on fxs port

Are you trying to make it so when a phone/port goes off-hook, a call is automatically completed?

New Member

Re: Plar on fxs port

That is exactly what I'm trying to do. Don't know about the original poster. Is this possible?

Hall of Fame Super Silver

Re: Plar on fxs port

With CallManager you can achive that with the right assignment of Calling Search Spaces, Partitions and Translation Pattern. Take a look at this document:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080232b9f.shtml

Chris

New Member

Re: Plar on fxs port

Hello,

Yes you can do it.

The analog FXS ports on the VG248 are basically mapped to emulated ip phones on the CallManager so this tech note should help you in configuring connection PLAR

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a0080232b9f.shtml

Best Regards.

149
Views
0
Helpful
4
Replies
CreatePlease login to create content