Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PLase Help with GK

Hi...I am new in this of Cisco Gk .

I have a Cisco 2600, an ATA186 and a Cisco AS5300.

I would like to make a test and I could not make it work. I would like to register my ATA to the GK, but not my AS5300. Then I would like to make a call from My ATA to the AS5300. How could I configre the GK to register my AS5300 as an tatic route (I am using the alias static command but is nor workin) My ATA is registring correctly to my GK (at least I think because it appears this in the GK

CallSignalAddr Port RASSignalAddr Port Zone Name Type F

--------------- ----- --------------- ----- --------- ---- --

xxx.xxx.xxx.xxx 1720 xxx.xxx.xxx.xxx 1719 GKt TERM

H323-ID: xxxxx

E164-ID: xxxxx

And the AS5300 appears also registered as static with the e164 ( I omit the number using x) xxxx.......

When I dial xxxx....... in my ata It does not connect to the as5300 (even though the as5300 has correctly configured the peer ) (becuase if I call direclty from the ATA to the gateway without GK it works)

PLease somebody help me with this

REgards.

1 REPLY
Cisco Employee

Re: PLase Help with GK

Check out the TAC GK & ATA docs in the H.323 TAC Support Page:

http://www.cisco.com/cgi-bin/Support/browse/psp_view.pl?p=Internetworking:H323&viewall=true

There are 4 docs that will help you get started to configure your GK.

- Carlos

84
Views
0
Helpful
1
Replies