Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Please Help! Analog Pickup Help Needed CME 3.3

Hello all!

I have a valcom paging system off of an FXS port. Calls come in, are transfered to the FXS port (x250). The ring voltage causes the paging system to emit a warble to tone so the plant floor knows the phone is ringing at night.

The problem is, noone can answer the call. It would seem like i could assign a pickup group number to the FXS port (like i have the IP phones) and they could just do gpickup 250 and get the call. But there isn't any option to assign a pickup group to this port.

Any suggestions on how i could get this working? It doesn't have to be gpickup, just so the unit emits the tone and the incoming call can be answered.

Thanks for your help!!

1 REPLY
Silver

Re: Please Help! Analog Pickup Help Needed CME 3.3

The new SCCP Analog (FXS) Ports group pickup is supported in 12.4 IOS .

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html

124
Views
0
Helpful
1
Replies