06-24-2006 02:48 AM - edited 03-15-2019 04:23 AM
Dear all,
i'm new to voice pls help me.
i have connected 2 offices using a p-t-p 128kbps leased line.routers are 2801.i have checked the connectivity
its fine.i'm using wic-1T for this connectivity on both sides. for voice purpose i have installed VIC2-FXS card.
my IOS on both sides are "c2801-ipvoice-mz.124-6.T2.bin".
and i have installed PVDM2-8 is installed on both routers.
my plan is to put 2 phones at each office.my phone is Ericsson phone model no is 4186 something its not an ip phone.so can i connect directly to fxs port.how can i configure this scenario.
i have a configuration with me can anybody verify this and give me guide lines.any reply will be appreciated with good rating.
please seee the config below.
Router> enable
Password:
Router# configure terminal
Router(config)# interface serial 0/0
Router(config-if)# ip rsvp bandwidth
Router(config-if)# ip rtp header-compression
Router# interface serial 0/0
Router(config-if)# mtu 300
Router(config-if)# interface serial 0/0.1 point-to-point
Router(config-if)# ip address 192.168.19.0 255.0.0.0
Router(config-if)# ip rsvp bandwidth
Router(config-if)# frame-relay ip rtp header-compression
West(config)# dial-peer voice 401 pots
West(config-dial-peer)# dest-pat +14085553737
West(config-dial-peer)# port 2/0/0
West(config)# dial-peer voice 402 pots
West(config-dial-peer)# dest-pat +14085554141
West(config-dial-peer)# port 2/0/1
West(config-dial-peer)# exit
West(config)#
East(config)# dial-peer voice 901 pots
East(config-dial-peer)# dest-pat +19199588282
East(config-dial-peer)# port 3/1/0
East(config)# dial-peer voice 902 pots
East(config-dial-peer)# dest-pat +19199589595
East(config-dial-peer)# port 3/1/1
East(config-dial-peer)# exit
East(config)#
Thanks in advance
Regds
Binoy
06-24-2006 04:00 AM
Is your routers configured with VOIP dial-peer?.
dial-peer voice 10 voip
destination-pattern 19T
session target EastrouterIP
dtmf-relay h245-alphanumeric
Let us know your problem.
Regards
Satish k
07-27-2006 10:01 AM
you need to configure VOIP peers to each location. therefore for location A to reach B
configure on A -
dial-peer voice X VOIP
destination-pattern (Extension pattern of analog phone at B
session target: ip address of Router B
dtmf-relay h245-alpha
do the same from B to A, obviously changing the destination-pattern and session target to suite.
finally, on the FXS port itself where u connect your analog phone, you can configure the extension of the associated phone by performing the following
enter the associated voice-port (e.g) if phone 1 is connected to voice-port 1/1/0 and you want phone 1 to have extension 333 then
voice-port 1/1/0
(voice-port)# station-id number 333
then save.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: