Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Polycom analog feature codes

We migrated from a Nortel PBX to Cisco CM with our Polycom analog phones connected to VG224s. However the codes we would use to transfer, conference, etc. no longer work. Assuming that our VG224 is configured correctly, is there a list of feature codes that I can use to see if these features are already programmed but I'm just using the wrong codes?

In other words, I need to know what keys to press on our SoundStation to transfer, conference, etc.

4 REPLIES
Hall of Fame Super Silver

Polycom analog feature codes

What protocol are you using to control the analog ports on VG224?

Supplementary codes are only supported with SCCP protocol, so MGCP/H323/SIP will not work with those.

HTH,

Chris

New Member

Polycom analog feature codes

The VG224 is using SCCP protocol.

Hall of Fame Super Silver

Polycom analog feature codes

New Member

Re: Polycom analog feature codes

It looks like we've got this figured out. When our system was installed the 'Multiple Call/Call Waiting Settings' for analog lines on the Directory Number Configuration page was not set correctly. The 'Maximum Number of Calls' and 'Busy Trigger' both need to be set to '2' in order for our feature codes to work. They were originally set to '1'.

Thanks for your responses.

675
Views
0
Helpful
4
Replies