Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Lockups

Unity 2.4.6 (135)

Cisco Unity TSP7.01

CCM 3.2(2c)

Unity is a four-port IP-only system...several issues recently started:

1. Garbled messages in Unity

2. Ports are locking up, mainly port 1, requiring a reboot of the system to resolve (short-lived) the issue.

2 REPLIES
Cisco Employee

Re: Port Lockups

Both of those problems can be the result of different causes. You could take a look at these docs that aid in the troubleshooting of problems like this...

1. Audio problems - (although the doc is 3.1.X based, there are still some applicable tips) http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_troubleshooting_guide_chapter09186a0080087146.html

2. Port Locks - http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080094b7d.shtml

New Member

Re: Port Lockups

For the port lockups, you might want to try this document that lists the troubleshooting steps plus some potential DDTS you might be encountering.

http://www.cisco.com/warp/public/788/AVVID/unity_port_lockups.html

For the garbled messages, are the actual voice messages garbled or is it the greetings? Is this happening for both internal calls (using IP Phones) and calls coming from outside like if you have a PSTN Gateway? What kind of codec are you using? Here is a good document about audio troubleshooting. http://www.cisco.com/warp/customer/788/AVVID/audio_decision.html

137
Views
0
Helpful
2
Replies
CreatePlease to create content