Now, I have centralized IPT infrastructure: CCM4.13 in SiteA and SRST in SiteB. SiteA has DID 021-686860XX and extension 60XX, SiteB has DID 001-363680XX and extension 80XX. I want to create a Router List including siteA voicegateway and siteB voicegateway for redundancy. But I find the prefix digits in router pattern is a difficult problem. Because the prefix digits is different in two sites voicegateway but the router pattern only adds a prefix digits.Do you have any better solution: if the router list check the caller ID is 60XX, it will add prefix digits 6868 and if it check the caller ID is 80XX, it will add prefix digits 3636?
The best practice is to manipulate digits on the route group insise route list, instead of route pattern for the exact same reason you are describing. This way you'll be able to prefix/strip different digits for each gateway.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...