Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

prefix on a VOIP dial-peer

I have a Manager Express in a router down in mexico. I have a full blown call manager here at our headquarters that I am looking to route all of our domestic long distance thru. Our local Call manager passes numbers on to our PBX with a 9 to notify it that it will be going out our long distance service.

My dial-peer in Mexico looks similar to this:

dial-peer voice 103 voip

description US Long Distance

translation-profile outgoing US-LD

preference 3

destination-pattern 2001[2-9]..[2-9]......

voice-class codec 1

voice-class h323 1

session target ipv4:x.x.x.x

dtmf-relay h245-alphanumeric

fax-relay ecm disable

no vad

the preference 3 is so that it doesn't use this till I have it right. In its current setup it will strip the 2001. (2 is for an outside line, 001 is to call U.S.) I need to add back on a 91 at the start. With a VOIP dial peer it is not allowing me to use the Prefix command I can with POTS. Is there a different command I should be using? or do I need to fix the missing characters in out local Call Manager?

Any suggestions would be appreciated.

Hall of Fame Super Silver

Re: prefix on a VOIP dial-peer

You have couple of options:

1. use translation pattern on the CCM to prefix the 9.

2. create a voice translation rule on CME and apply it to the dial-peer, such as:

voice translation-rule 1

rule 1 /^200\(1..........\)/ /\1/

voice translation-profile 1

translate called 1

dial-peer voice 103 voip

translation-profile outgoing 1

HTH, please rate all posts!


New Member

Re: prefix on a VOIP dial-peer

2 methodes

- translation profile for aoutgoing called on the router

- or on the callamanger you can transform the route patern

CreatePlease login to create content