I am having a Voice gateway router where a PRI has been connected. I am using 4 digit extensions using in my network with Cisco Call Manager. I have created dial-peers with "destination-pattern ...." pointing to my Call Manager.
My service provider is sending only 3 digits to my router. Suppose if I am having a DID number of 28971234 for my extension 1234, I am getting only the last 3 digits ie 234 in my router. So in this case, router is not able to route the calls.
What shall I do in my router so that he will prefix 1 before 234 , make it 1234 and send it to Call Manager?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.