Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PRI and ATA186

Hi,

I have the following problem:

100->PBX->pri->router3725-lan-router806->ata186->310

where 100 and 310 are two phone extensions

when I'm dialing from 310 to 100 the router is disconnecting with the message "Cause i = 0x82C1 - Bearer capability not implemented"

if i shutdown the dial peer 300, the call succedes, what is happening? what I'm missing?

router3725#

interface Serial1/0:15

no ip address

no logging event link-status

isdn switch-type primary-net5

isdn protocol-emulate network

isdn incoming-voice voice

isdn T310 6000

isdn bchan-number-order ascending

no cdp enable

!

dial-peer voice 300 voip

destination-pattern 31.

session target ipv4:10.20.10.2

!

dial-peer voice 100 pots

destination-pattern 1..

direct-inward-dial

port 1/0:15

forward-digits all

!

Thank you very much!!

1 REPLY
New Member

Re: PRI and ATA186

I made it ..it was the codec...

thanks

284
Views
0
Helpful
1
Replies
CreatePlease to create content