I've got a 6608 PRI blade and a third party voicemail system. The VM system runs on a win2k pc. We need to hook up the VM system to the Cisco system via a T1 connection to the 6608. The VM provider is just getting support for T1 and so far are only talking about using the dialogic PRI cards. D/240JCT-T1 is one example.
Is it possible to hook up PRI in a back to back configuration? I thought you had to have an ISDN switch between two PRI user nodes? Can the 6608 or the dialogic act as the network? Would I be doing PRI QSIG in this environment?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...