We are setting up 2 sites for VOIP. these 2 sites are connected by 3640's.
siteA will have the call manager. siteB will have a PRI with DID's coming in the 3640. So the DID comes in siteB's PRI then must be routed to call manager over a T1 in siteA then Call Man must ring a phone in siteB. . question is How do I route the DID coming in siteB's PRI to call manager in siteA ? I know once the DID gets to CALL Man in site A it will have no problem ringing the phone in siteB but what command in siteB's 3640 will route incoming DID's to siteA ?
Build VOIP dial-peers whose destination patterns match your incoming numbers. Use wild cards to cut down on the number of VOIP dial-peers, or use the num-exp IOS command. The session target is the IP of your CallManager. If you are going to use the site B 3640 for "tail-end hop off", you'll build the router as a gateway too.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...