PRI CCP

[m.hedberg]

We are setting up 2 sites for VOIP. these 2 sites are connected by 3640's.

siteA will have the call manager. siteB will have a PRI with DID's coming in the 3640. So the DID comes in siteB's PRI then must be routed to call manager over a T1 in siteA then Call Man must ring a phone in siteB. . question is How do I route the DID coming in siteB's PRI to call manager in siteA ? I know once the DID gets to CALL Man in site A it will have no problem ringing the phone in siteB but what command in siteB's 3640 will route incoming DID's to siteA ?

[mwheinz]

Build VOIP dial-peers whose destination patterns match your incoming numbers. Use wild cards to cut down on the number of VOIP dial-peers, or use the num-exp IOS command. The session target is the IP of your CallManager. If you are going to use the site B 3640 for "tail-end hop off", you'll build the router as a gateway too.