Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PRI line to Definity G3

I am installing a t1 pri line from our router to our

Definity G3 .

I'm currently having sync problems.LAYER 1

Can anyone supply me with the configs of a working PRI gateway that is not controlled via MGCP.

I would also like any configs on the G3.

Thanks

2 REPLIES
New Member

Re: PRI line to Definity G3

These may help.

Configuring support for PBX signalling: Q.SIG Signalling support

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/multi_c/mcprt1/mcdpbxsg.htm

Connecting to a Lucent Definity with T1 PRI Signaling

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/sw_conf/pbx_int/36ldt1pr.pdf

New Member

Re: PRI line to Definity G3

Hi Pablo,

as you have seen you have a physic problem. What type of cabling do you have? do you use standart cabling? I have been involved in a same symptomatic problem. My cabling spec from router PRI to PBX was CAB-E1-RJ45BNC. I resolved my problem changing the bcn cables, I did not connect correcty.

Luck,

Sergi.

107
Views
0
Helpful
2
Replies
CreatePlease to create content