Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRI not registering after router reload

I had a strange issue occur today. When I rebooted the router everything came up with no issue except for my t1 PRI. The L2 status was stuck in TEI_Assigned. The only resolution was to do a 'No MGCP' followed by 'MGCP'.

Any thoughts?

3825 MGCP Gateway running 12(4)T with CM 4.1(3)

3 REPLIES
Green

Re: PRI not registering after router reload

We may have checked:

debug isdn q921

debug mgcp packet

debug ccm-manager backhaul

show ccm-manager

and CCM trace.

Will look for existing DDTS and let u know.

Re: PRI not registering after router reload

What version of 12.4T exactly, and can you post the global ccm-manager commands from your config and global mgcp commands. Also, a 'show ccm-manager'.

New Member

Re: PRI not registering after router reload

IOS Version:c3825-adventerprisek9-mz.124-4.T.bin

Attached are the commands you requested.

I did do the debug q921, but I did not save the logs, because I was wanting to get the line up quickly. Let me know if the attachments help out.

Thanks,

375
Views
0
Helpful
3
Replies
CreatePlease login to create content