I have a PRI that connects a 3640 voice gateway to a Nortel PBX. I need to know what is the maximum number of voice channels that have ever been simultaneously used on this PRI. In other words what is the maximum # of simultaneous voice calls currently processed between the 3640 and PBX. I know that I can use the command "sh voice call summary" on the 3640 and see the current number of voice calls on the PRI. But, I need to see the maximum number of simultaneous calls ever processed. Any ideas? Thanks.
One idea might be to use the perfmon too on the callmanager and put a watch on the number of active channels on a particular PRI span under the Call manager Gateway object (MGCP or H323 dependeing on your method of gateway). You could then go back through the logs on perfmon after saving them and look for the high point. There are doubtless better ways but this might be one option.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...