We are migrating a legacy PBX system to IPT. We had 20 Analog lines from the PSTN going to the PBX sone of which were private lines that would ring on specific individuals desks. We are considering replacing the 20 Analog lines with a T1 PRI from the Telco. The T1 will be terminated on a 2620XM. Our challenge is to have the same scenario in the IPT environment as was in the Legacy environment (private lines via the PBX). Will it be possible to have a specified channel on the T1 line ring on a specific user's IP Phone, thus creating a private line for that user?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...