Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem about 3640 connected Alcatel 4400 with Qsig.

hi,

3640 with E1 connected Alcatel 4400 with QSIG. Alcatel 4400 sent digits to 3640 which can't recognize at first. We have to redial some digits to make the call successful. the following is the message debug.

Does anyone give me some advice ?

best regards

fred.

Calling Party Number i = 0x0081, '88055700', Unknown/Unknown

03:12:01: Called Party Number i = 0x80, '3', Unknown/Unknown

03:12:01: High Layer Compat i = 0x9181

03:12:01: Locking Shift to Codeset 5

03:12:01: Codeset 5 IE 0x32 i = 0x81

03:12:4294967296: ISDN Se1:15: TX -> SETUP_ACK pd = 8 callref = 0x8005

03:12:4317272088: Channel ID i = 0xA98386

03:12:02: ISDN Se1:15: RX <- INFORMATION pd = 8 callref = 0x0005

03:12:02: Called Party Number i = 0x80, '3', Unknown/Unknown

03:12:09: ISDN Se1:15: RX <- INFORMATION pd = 8 callref = 0x0005

03:12:09: Called Party Number i = 0x80, '3', Unknown/Unknown

03:12:09: ISDN Se1:15: RX <- INFORMATION pd = 8 callref = 0x0005

03:12:09: Called Party Number i = 0x80, '7', Unknown/Unknown

03:12:10: ISDN Se1:15: RX <- INFORMATION pd = 8 callref = 0x0005

03:12:10: Called Party Number i = 0x80, '0', Unknown/Unknown

03:12:10: ISDN Se1:15: RX <- INFORMATION pd = 8 callref = 0x0005

03:12:10: Called Party Number i = 0x80, '0', Unknown/Unknown

1 REPLY
Bronze

Re: problem about 3640 connected Alcatel 4400 with Qsig.

Hi,

it seems you have Problems with the "Numbering Plan Description " on the 4400. Try to change the NPD on the 4400 to "isdn national" for Calling Number and "Isdn Unknown" for the Called number.

Hope this Helps

Mehmet

104
Views
0
Helpful
1
Replies
CreatePlease login to create content